General Use Stem Bumpers
Bumper, hood ventilator door, self retaining. Five sixteenths (5/16) inch diameter, forty eight (48) piece set.
Corner stop, hood louver, self-holding, original size and profile, fits one fourth (1/4) inch hole in sheet metal.
Bumper, trunk lid.
Bumper, hood, rubber only. One and one eighth (1-1/8) inch outside diameter. Fits five eighths (5/8) inch hole, one half (1/2) inch high.
Hood bumper set. Kit includes two (2) each of our #33-0123-42 bumpers and six (6) each of our #33-0459-42 bumpers.
Hood bumper set. Kit includes two (2) each of our #33-0046-42 bumpers, two (2) each of our #70-0294-42 bumpers, and six (6) each of our #33-0427-42 bumpers.
Bumper, taillight body upper half and fuel filler cover to lower half. Four (4) per set.Length: .8125 inches. Width: .5 inches.
Bumper, door, lower, held by one (1) screw and one (1) carrot retainer.Length: 1.125 inches. Width: .625 inches.
Grommet, cowl gutter drain hose. Nine sixteenth (9/16) inch hole through cowl side wall, five sixteenths (5/16) inch inside diameter. Two (2) per car.
Cushion (stem bumper), window stop, lower. For front and rear door, rear side and quarter windows as required. (See sketch and our #33-0540-62).
Bumper, window stop. One and one fourth (1-1/4) inch square by one half (1/2) inch thick. Compare with our #33-0540-62 and #33-0675-62.Length: 1.
Cushion (stem bumper), window stop, lower. For front and rear door, rear side and quarter windows as required.
Bumper, windshield post (side arm). Replaces #366138. Two (2) per car.
Bumper, between grill and fender. One fourth (1/4) inch thickness, five sixteenths (5/16) inch sheet metal holes.
Bumper, door side. Four (4) used per car. Not a generic substitute, but manufactured just like the factory original.
Bumper, door, used upper and/or lower as required. Excellent detail using highest quality rubber.Length: .875 inches. Width: .8125 inches. Height: 1.
Bumper, fender extension to quarter panel. Fully molded rubber. One and one fourths inch (1-1/4") length by eleven sixteenths inch (11/16") base diameter.
Bumper, license plate. Fully molded rubber. Seven sixteenths inch (7/16") head length by one and one sixteenth inch (1-1/16") overall length.
Bumper, lower radiator panel to grille, four (4) per car. Also used on radiator valance, two (2) per car in year 1941 only. Compare with our #33-0211-31. Also used as a bumper, hood tip panel to grille. Use 10 per car for 1939-1940 models. Use 8 per car
Bumper, front door pillar, upper and lower.