Please click on the part name in red in order to get a complete description.
Bumper, hood to fender ledge. Up to ten (10) used per car.
Pad, hood, stem bumper type.
Bumper, hood to fender side. Four (4) required per car.
Hood corner pad
Bumper, hood. Use as required. Width: .6875 inches. Height: .625 inches.
This Hood Bumper is quality reproduction of the original factory part.
This Hood to Fender Bumper is quality reproduction of the original factory part. This rubber bumper attaches to the front fender to support / cushion the hood closure. Usually requires up to ten (10) bumpers per vehicle.
Bumper, hood to fender.Length: 1.0 inches. Width: .875 inches.
Bumper, front and rear body hinge pillar, one (1) inch diameter by one fourth (1/4) inch thick, held by screw, steel core. Auxiliary, used only where needed to prevent door rattle.Note: also used on 1942-50 Packards with Clipper styling near t
Bumper, hood to fender ledge. Four (4) piece set.
Bumper, hood to fender side, at front.
Bumper, hood to fender ledge. Excellent reproduction, made just like original.
Pad, hood rest rod. For five sixteenths (5/16) inch diameter hood support rod. Also see our #40-0103-42.Length: 1.0 inches.
Bumper, hood, rubber only. One and one eighth (1-1/8) inch outside diameter. Fits five eighths (5/8) inch hole, one half (1/2) inch high.
Bumper, hood to fender ledge.
Bumper, fender to hood. Two (2) per car. Held by four (4) rivets.Length: 2.9375 inches.
Pads, hood corners, front and rear.Length: 1.25 inches.
Pad, hood panel center bracket. Hollow, to fit over original steel bracket.Length: 1.375 inches. Width: 1.375 inches.
Pads, hood corners. Square type, brass core. Integral installation tabs. 90 degree angle, used on front or rear corners, as required.
Pads, hood corners, brass core. Approximately 80 degree angle. Integral tabs for installing.Length: 1.50 inches.