Search Results

28 items found matching 1940 in Electrical, NonLighting
The listing below contains just short, abbreviated descriptions.
Please click on the part name in red in order to get a complete description.
Coil wire sleeve

p/n: 14-0022-21

Sleeve, spark plug wires from distributor to wiring tube, rubber only.

Made to Order Takes 1-2 Days
Wiring grommet

p/n: 70-0709-21

Grommet, horn wire exit from horn motor cover. Eleven thirty seconds (11/32) inch inside diameter. Two (2) per car.

In Stock
Horn button contact cushion

p/n: 50-0409-21

Separator, horn contact. For standard or non-flexible wheel.

In Stock
Antenna boot

p/n: 70-0212-21

Boot, runningboard antenna wire connection.

In Stock
Horn button contact cushion

p/n: 60-0344-21

Cushion, horn blowing button.Height: 1.0 inches.

In Stock
Brown starter button cover

p/n: 40-0419-89

Pad, starter button. Made with brown rubber like original.

Made to Order Takes 1-2 Days
Horn button contact cushion

p/n: 60-0520-21

Cushion, horn blowing ring.

Made to Order Takes 1-2 Days
Antenna mount pad

p/n: 70-2698-21

Pad, vacuum antenna mount, on fender.Width: 2.0625 inches. Height: 1.5 inches.

In Stock
Starter button

p/n: 60-0322-21

Starter button, push on replacement to rod. Two (2) inch outside diameter.

Made to Order Takes 1-2 Days
Starter solenoid boot

p/n: 70-0371-21

Boot, starter solenoid.

In Stock
Starter pedal pad

p/n: 25-0049-89

Pad, starter pedal. Original pattern, brown rubber, exact copy.Height: .50 inches.

In Stock
Battery carrier edge liner

p/n: 27-0091-21

Seal strip, battery to fender apron. Two (2) correct cross section strips nineteen (19) inches long.

In Stock
Starter rod boot

p/n: 40-0472-89

Seal, starter through floorboard.

In Stock
Battery cable boot

p/n: 70-0704-21

Boot, battery cable at starter solenoid.Width: 2.75 inches.

In Stock
Electrical terminal boot

p/n: 30-0279-41

Boot, electrical connection, generator terminal or ignition coil at engine.

In Stock
Starter button cover

p/n: 60-0166-21

Cover, starter pedal button. Rubber slip over type for old metal. Two (2) inch outside diameter. If car doesn't have old metal, see our #60-0322-21.

In Stock
Battery clamp cover

p/n: 70-0095-21

Cover, battery clamp. Control unsightly sulfate buildup. Help protect the nearby metal and finish. Good copy from original part.Length: 3.5 inches.

In Stock
Battery strap grommet

p/n: 50-0316-21

Grommet, battery hold-down strap.

In Stock
Spark plug retaining ring

p/n: 30-0352-21

Retaining ring, spark plug wire. Two (2) per car.Chevrolet 1935-48 Retaining ring, spark plug wire. Two (2) per car. All models.

In Stock
Antenna mount pad

p/n: 50-0168-21

Pad, antenna mounting over windshield, one and thirteen sixteenths (1-13/16) inch outside diameter, one and one fourth (1-1/4) inch inside diameter.

Made to Order Takes 1-2 Days
Starter pedal bellows

p/n: 60-0210-21

Bellows, starter pedal shaft to floorboard. Three eighths (3/8) inch top hole with three (3) inch height.Width: 2.875 inches. Height: 3.0 inches.

In Stock
Spark plug wire spacer

p/n: 30-0313-21

Spacer, spark plug cable. Three (3) hole as original.

In Stock
Horn Projector Grommet

p/n: 20-1562-21

Grommets, horn bell to bracket.

Ships In 3-4 Days
Coil wire sleeve

p/n: 70-1179-21

Sleeve, coil wire to distributor. Fluted to match upper water hoses rubber only.

In Stock
Spark plug grommet

p/n: 70-1181-21

Grommet, spark plug and coil wire at distributor cap outlets. For seven (7mm) millimeter, later years.

In Stock
Spark plug grommet

p/n: 70-1180-21

Grommet, spark plug & coil wire at distributor cap outlets. For nine (9mm) millimeter wire, earlier years.

In Stock

p/n: 30-0404-48

Insulator, used on various places on vehicle. 1937: Eight (8) required per car for horn bracket to dash 1937-39: Uses 6 per car for muffler rear support bracket. 1938-40: Uses 10 to 14 per car runningboard to frame bracket 19

In Stock
Battery hold down bracket pad

p/n: 20-2305-21

Pad, battery hold down bracket.

Ships in 3-4 Days