Please click on the part name in red in order to get a complete description.
Pad, rear hood corners, brass core as original.Length: 5.50 inches.
Pads, hood front corners, exact copy with metal core as original. Right and Left.Width: 2.50 inches.
Guard strip, hood to cowl. Brass core with molded integral hood rest.Length: 14.875 inches.
Pad, front hood corners, exact copy of original.Width: 2.75 inches.
Protector, hood center. Brass core as original threaded to fit original screws.
Bumpers, hood top panel to side panels. Four (4) piece set with brass core as original. Four (4) per vehicle.
Pads, hood front corners. Large self prong type with metal core molded left and right.Length: 3.375 inches.
Pads, hood rear corners, exact copy with metal core as original. Right and Left (reversible).Width: 2.50 inches. Height: 1.75 inches.
Pads, hood corner, right and left. Threaded brass core.
Pads, hood front corners. 2 rivet type.Length: 3.25 inches.
Pads, hood corners, front. Original type with metal core and retaining tab.Width: 1.625 inches.
Pads, hood corners, rear. Original style with metal core and metal fastening tabs.
Pads, hood corners, brass core. Approximately 80 degree angle. Integral tabs for installing.Length: 1.50 inches.
Pads, hood corners. Square type, brass core. Integral installation tabs. 90 degree angle, used on front or rear corners, as required.
Bumper kit, hood. Sixteen (16) piece set.
Pad. hood corner, steel core as original, front and rear.Length: 1.5 inches.
Bumper kit, hood.
Bumper, hood side panel center.Length: 2.125 inches. Width: .75 inches.
Bumper, inner hood rest. Good copy and material. One (1) pair required per car.Length: 1.50 inches. Width: .875 inches.
Bumper, hood, rubber only. One and one eighth (1-1/8) inch outside diameter. Fits five eighths (5/8) inch hole, one half (1/2) inch high.
Top cap, hood support rod. For seven sixteenths (7/16) inch diameter rod. Also see our #40-0346-42.Length: 1.0 inches.
Pad, hood rest rod. For five sixteenths (5/16) inch diameter hood support rod. Also see our #40-0103-42.Length: 1.0 inches.
Gravel shield, front bumper, anti-rattle.
Pads, upper hood hinge.
Bumper, front and rear body hinge pillar, one (1) inch diameter by one fourth (1/4) inch thick, held by screw, steel core. Auxiliary, used only where needed to prevent door rattle.Note: also used on 1942-50 Packards with Clipper styling near t
Hood corner pad
Bumper, hood to radiator. Six (6) per vehicle.
Pad, hood ornament base. Paper.
Pad, hood, stem bumper type.
Bumper, trunk or hood. Molded with clearance for screw. Used for: Buick 1942-50 Bumper for trunk. Chevrolet 1949-55 Bumper for rear hood corners on cowl. Chevrolet 1949-50 Bumper for trunk. Oldsmobile 1938 Bumper under hood corner on radi