Please click on the part name in red in order to get a complete description.
Bumper kit, hood. Ten (10) piece set.
Seals, hood hinge assembly to body.
Lacing, hood cowl.
Hood bumper set. Kit includes two (2) each of our #33-0123-42 bumpers and six (6) each of our #33-0459-42 bumpers.
Bumper set, hood.
Bumper, hood, on side of fender. Six (6) required per car.Length: 1.0 inches. Width: 1.375 inches.
Bumper, hood to fender, side.Length: 1.1875 inches. Width: .8125 inches.
Bumper, hood to radiator grille frame. Four (4) per car, normally.
Bumper, hood side to fender. Four (4) per car.
Bumper assembly, seven eighths (7/8) inch diameter by three eighths (3/8) inch bumper on 1/4-20 stud.Height: 1.50 inches.
Bumper, hood to fender. Uses four (4) per car for most models.Width: 1.375 inches. Height: 1.25 inches.
Bumper, hood side upper. Fully molded, authentic configuration for 1/4" hole. Six (6) typically required per vehicle. Note: This part is included in our 90-0213-90 Body Bumper
Bumper, hood to cowl, intermediate. Attaches to our hood to cowl weatherstrips, .34 inch high. Use as required four (4) to six (6) per car. For .
Bumper, hood to cowl, intermediate. Attaches to our hood to cowl weatherstrips, .28 inch high. Use as required four (4) to six (6) per car. For .
Bumper, hood to cowl, intermediate. Attaches to our hood to cowl weatherstrips. Use as required, four (4) to six (6) per car. For .
Pad, hood side to fender. Button type, fits five sixteenths (5/16) inch hole, self retaining.
Bumper, front fender to hood.
Bumper, hood rest, cap type for adjustable screw, fifteenth sixteenths (15/16) inch, seven sixteenths (7/16) inch thick.
Bumper, hood to cowl and door hinge pillar upper. May be used in both places.
Bumper, hood panel to fender.
Pad, hood rest, front, to radiator header bar (top of grille).
Bumper, trunk or hood. Molded with clearance for screw. Used for: Buick 1942-50 Bumper for trunk. Chevrolet 1949-55 Bumper for rear hood corners on cowl. Chevrolet 1949-50 Bumper for trunk. Oldsmobile 1938 Bumper under hood corner on radi
A quality plastic button-head push-in fastener with self-retaining barbs. Typically used for hood to cowl weatherstrips, but also has other uses. The fastener length is three-fourths (3/4") inch with a five-eights (5/8") inch smooth button-head. Will fit a five-sixteenths (5/16') inch hole.