Weatherstrip, windshield lower. Height: .5625 inches.
This windshield gasket set contains two (2) seals that mount around the perimeter's of both pieces of glass. It also has properly molded corners for a precise, factory fit.
Weatherstrip, rear vent window, right and left, perfect copy.
These front door vent window weatherstrips are designed from the original parts for a precise, factory fit. They are molded as left and right and have the correctly placed, pre-drilled pivot holes.
This rear window gasket set mounts around the two (2) separate back windows. They are molded as left and right with properly shaped corners for a precise, factory fit.
This rear window gasket set mounts around the two (2) separate back windows. They have vulcanized, or bonded, ends which means no cutting or splicing is required for installation.
Seal, steering box cover.Width: 7.50 inches.
Motor mount. Revulcanization service only.
This rear window gasket is designed from the original part for superior fitment and seal. The seal mounts around the full perimeter of the back glass and has vulcanized, or bonded, ends which means no cutting or splicing is required for installation.
Weatherstrip, windshield to dash (anti-glare). 2 piece set.
Seal, headlight bucket to bracket.Width: 7.0 inches.
Pad, accelerator pedal. Original pattern, superior workmanship.
Pads, clutch and brake pedal.
Grommets, front and rear bumper arm. Fully molded rubber, slightly angular. Two and seven eighths inch (2-7/8") outside length by two and three fourths inch (2-3/4") outside width by one and three eighths inch (1-3/8') inside hole diameter by one inch (1"
Pad, headlight mounting bracket. Length: 6.0 inches.
Grommet, fuel filler neck. Oblong, fully molded rubber. Three and one fourth inch (3-1/4") outside length by two and three sixteenth inch (2-3/16") inside diameter.
Weatherstrip, door opening, special bulb seal with lip to fit original retainer. Approximately 46 inch strip.Width: .375 inches. Height: .625 inches.
Gasket, cowl vent. Perfect copy of original, not a sponge substitute, top quality material.
Grommet, steering column floor seal. One and one half (1-1/2) inch inside diameter, two and one half (2-1/2) inch outside diameter.
This divider bar is used to seal and separate the two glasses of the rear window. It is designed to be used along with one of our rear window gasket weatherstrips.
Bushing, spring bracket on frame (Auburn and Cord 810 & 812). Also used as a grommet, front stabilizer bar (Graham models 116 & 120). Fully molded rubber. One and five eighths inch (1 5/8") outside diameter by three fourths inch (3/4") inside hole diamete
Bushing, for shock absorber link cross pin or stabilizer link cross pin.1931-36 Bushing, rubber, for shock absorber link cross pin, #41151.
Pad, door side bumper. Clip retained.
Bushing, shock absorber arm link.
Channel, windshield, for windows without chrome reveal molding. (With 2 piece windshield, select gasket for division bar).
Bumper, standard, self retaining.