Please click on the part name in red in order to get a complete description.
Gasket, signal/backup light lens. Die cut sponge rubber to authentic original dimensions.
Seal, rear door at rear hinge. Installs with glue to rear door where hinge arm goes into door. 4-piece set.
Rear Finish Panel to Package Tray Weatherstrip - This weatherstrip attaches to the trunk body and seals between the finish panel and the package tray near the convertible top when closed.
Bumper, hood-to-cowl. Mounts with screws on cowl directly behind the hood to cowl seal. 2 needed per car.
Bushing, shock absorber and stabilizer, as needed. Fully molded rubber. One and seven sixteenths inch (1 7/16") length by five eighths inch (5/8") inside hole diameter by one and one eighths inch (1 1/8") outside diameter.
Bumper, hood-to-cowl adjustable. Includes attaching screw.
Bumper, hood to fender. Attaches in slot in jamb area of engine compartment. Two (2) per side. Four (4) piece set.
Hood Bumper, radiator support hood. Includes jamb nut. Vulcanized "Rounded Top" type. Two (2) required per car.
Bumper, door side. Five eighths (5/8) inch by seven eighths (7/8) inch by one and seven sixteenths (1-7/16) inch. Two (2) door.
Pad, door side bumper. Clip retained. Appears identical to Atwood #107, #208.Width: 1.5 inches. Height: 1.3125 inches.
Bumper, hood, front adjustable. Bumper threads into radiator support on left and right side. Two (2) required per car.
Seal, door inner panel drain. Attaches to bottom of door with one (1) carrot retainer on either end.
Grommet, spare wheel brace for sidemount wheels, at runningboard apron, four (4) per car. Sheet Metal Hole: 1-1/2" Center Hole: 1/2" Outside Diameter: 1-13/16" Slot Width: 1/16"
Weatherstrip, side window.Ford Cars 1931-39 Weatherstrip, side window, certain Lincoln K-models with Coachmaker bodies.
Bumper, hood adjustable, rear. Slip-over rubber cover for threaded stud that mounts on both sides of cowl.
Bumper, hood-to-cowl. Mounts in center of cowl beneath back of hood.
Channel, windshield mounting with three eighths (3/8) inch wide opening and one eighth (1/8) inch diameter retaining bead, for metal frame around
Grommet, shock absorber mounting, plain cylinder type with flat ends.
Bumper, door. Requires two (2) per door - one (1) upper on door and one (1) lower on door.
Grommet, headlight and horn conduit through fender, made to clear nut on end of conduit. Three (3) per car. Sheet Metal Hole: 15/16" Center Hole: 1/4" Outside Diameter: 1-1/4" Slot Width: 1/16"