This windshield gasket mounts around the full perimeter of the front glass and has the divider bar molded directly into it. It has properly molded corners to precisely conform to the glass and has the slot to accommodate the outer edge's decorative molding.
Original equipment style side window horizontal seal kit (also known as beltline weatherstrip). Four (4) piece kit that includes inner and outer window felt beltline weatherstrip for each front door. These felt strips wipe the side windows when the glass is lowered.
This rear window gasket is designed from the original part for superior fitment and seal. The seal mounts around the full perimeter of the back glass and has vulcanized, or bonded, ends which means no cutting or splicing is required for installation.
This door weatherstrip set is designed from the original parts for a superior fitment and seal. The four (4) piece set contains the lower and upper door seals which provide complete coverage for both doors.
Seal, radiator air deflector top of radiator. Three (3) piece set.
Seal, rear bumper stone deflector. Three (3) piece set.
Seals, brake and clutch arm.
Pad, luggage compartment door handle.
Pad, fenderskirt edge, similar to our #70-0055-45, but thinner. Approximately five (5) foot strip per skirt.Length: 60.0 inches. Width: .15625 inches.
Pads, brake and clutch pedal. Standard transmission.
This trunk weatherstrip is designed from the original part for superior fitment and seal. The seal mounts around the full perimeter of the trunk lid.
Seal pad, rubber tape. Fifteen (15) foot roll.
Grommet, fuel filler neck.
Pads, windshield wiper pivot. Use when windshield washer is part of wiper pivot. Replaces factory #8M-17541-B.
Grommets, door handle outside.
Seal, steering column tube. Installs on top of floor mat.
Kit, cowl lacing. Includes special tacks.
Bumper kit, hood.
Seal, top outside corners of cowl to hood. Includes left and right side.
Bumper, rear lamp bracket. Type w/Tire Carrier.
Hose, fuel tank to filler neck.
Repair kit, gear shift lever grommet. Column shift only. Two (2) kits required.
Grommet, glove compartment door check arm.
Seals, brake and clutch pedal arms to floor board.
Seals, tie rod end. Four (4) piece set.
Seals, taillight lens to housing.
Gaskets, parking light lens to housing.
Grommet, main wiring loom firewall.
Grommet, door lock button to garnish molding.
Pads, door lock cylinder assembly to door.
Seal, front suspension. Inner upper arm.Qty Required:4 Four (4) required per car.
Grommet, wiper arm to motor. Replaces factory #51A-17562.
Seal, idler arm. Two (2) required per car.
Grommet, wiper hose. Replaces factory #8A-17545-S.
Grommet, speedometer cable firewall.
Grommet, air vent cable through firewall. One pair required per vehicle.
Seal, front suspension. Inner lower arm.Qty Required:4 Four (4) required per car.
Grommet, front shock absorber. Four (4) required per shock.
Grommet, rear shock absorber.
Bushing, shock absorber link. May be used for front or rear spring.Chrysler 1951-54 Bushing, rubber, shock absorber link.
Plug, cowl and floor pan. This body plug covers a sheet metal hole that is one and one fourth (1-1/4) inch in diameter.
Plug, cowl and floor pan. Three fourths (3/4) inch.
Bumper, door check arm.