Search Results
Please click on the part name in red in order to get a complete description.
Windshield Gasket
p/n: 20-2518-50
This windshield gasket mounts around the full perimeter of the front glass and has the divider bar molded directly into it for a precise, factory fit.
Front Door weatherstrip
p/n: 20-2598-72
Door edge weatherstrip. This part is the primary door to body weatherstrip.
Liftgate Weatherstrip
p/n: 20-2622-85
This liftgate weatherstrip is designed from the original part for superior fitment and seal. The seal mounts around the full perimeter directly to the liftgate.
Tailgate Primary Side Weatherstrip
p/n: 20-2621-85
These tailgate weatherstrips are designed from the original parts for superior fitment and seal. These seals mount on the side and bottom corners of the tailgate.
Side window weatherstrip
p/n: 20-2557-62
Seal, special window-sweep. Station Wagons only: Rubber that goes between door glass and staples to wooden frame. Use on door and quarter windows.
Fenderskirt edge seal
p/n: 20-0111-44
Pad, fenderskirt edge, similar to our #70-0055-45, but thinner. Approximately five (5) foot strip per skirt.Length: 60.0 inches. Width: .15625 inches.
Flexible run channel
p/n: 20-1619-58
Channel, door glass flexible run. Fabric covered bead. Sixty (60) inches long. Measures 9/16” tall x 5/8” wide. Used with 1/4” glass.
Flexible run channel
p/n: 20-1146-58
Channel, flexible door window run. Stainless steel beaded. Sixty (60) inches long.
Beltline weatherstrip
p/n: 40-0539-57
Window felt inner and/or outer. One (1) pair of three (3) foot lengths. Flexible, pile lined, rubber covered, with black bead. For front door, rear door and quarter windows.
Beltline weatherstrip
p/n: 70-0555-58
Weatherstrip, door window inner and outer, front and rear doors. Seven sixteenths (7/16) inch wide, with chrome bead, mohair faced, flexible. Two (2) three (3) foot strips. Bend to fit.
Tailgate Secondary Side Weatherstrip
p/n: 20-2624-85
These tailgate weatherstrips are designed from the original parts for superior fitment and seal. These seals mount on the side of the tailgate.
Side window weatherstrip
p/n: 30-0244-57
Window felt inner and/or outer. One (1) pair of three (3) foot lengths. Flexible, pile lined, rubber covered, with black bead. For front door, rear door and quarter windows.
Engine Mount
p/n: 20-2401-11
Front Engine Mount - Two (2) required per car. Ford only 6 or 8 cylinder engines.
Air ventilator seal
p/n: 20-2965-31
Seals, air vent damper. Must drill out spot welds to replace the cracked rubber. Includes screws to put back together.
Tailgate Lower Weatherstrip
p/n: 20-2623-85
This tailgate weatherstrip is designed from the original part for superior fitment and seal. The seal mounts on the bottom of the tailgate.
Steering column floorplate
p/n: 20-1694-88
Seal, steering column tube. Installs on top of floor mat.
Gearshift grommet
p/n: 20-2460-26
Repair kit, gear shift lever grommet. Column shift only. Two (2) kits required.
Door handle gasket
p/n: 20-2584-69
Pads, outside door handle. Set includes four (4) pieces for two (2) handles.
Front suspension bumper
p/n: 20-2475-32
Bumper, front suspension lower arm. Bumper section is 2" tall and 1-15/16" wide.
Spring shackle bushing kit
p/n: 20-2481-33
Bolt and bushing, front of rear spring. Two (2) kits required per car.
Steering column floorplate
p/n: 20-2641-88
Seal, Ford-o-matic transmission steering post to floor. Installs under metal plate.
Steering column floorplate
p/n: 20-2646-88
Seal, standard trans. steering post to floor. Installs under metal plate.
Front bumper grommet
p/n: 20-2507-45
Grommets, front stone deflector to bumper arm anti-rattler. Four and one half (4-1/2) inch long. Two (2) piece set.
Wiper control grommet
p/n: 20-2526-53
Gaskets, wiper pivot spacer to body. Replaces factory #8A-17541-B.
Front suspension bushing
p/n: 20-2471-32
Seal, front suspension. Inner upper arm.Qty Required:4 Four (4) required per car.
Front suspension bushing
p/n: 20-2474-32
Seal, front suspension lower control arm outer. Four (4) required per car.
Taillight lens gasket
p/n: 20-1988-15
Gasket, taillight lens. Inner and outer seal. Enough for one taillight lens.
Glovebox and fuel door bumper
p/n: 20-1220-88
Bumpers, glovebox and/or fuel filler door. Used as glove box door bumpers for all models listed, used as fuel door bumper for 1950-51 cars and 57-59 retractables only.
Body Hole Plug
p/n: 20-1041-21
Plug, cowl and floor pan. This body plug covers a sheet metal hole that is one and one seven eighths (1-7/8) inch in diameter.
Vent Cable Thru Firewall Grommet
p/n: 20-2437-20
Grommet, air vent cable through firewall. One pair required per vehicle.
Front suspension bushing
p/n: 20-2470-32
Seal, front suspension. Inner lower arm.Qty Required:4 Four (4) required per car.
Front suspension bushing
p/n: 20-2473-32
Seal, front suspension outer upper arm. Four (4) required per car.
Shock absorber bushing
p/n: 20-1274-32
Bushing, shock absorber link. May be used for front or rear spring.Chrysler 1951-54 Bushing, rubber, shock absorber link.
Body Hole Plug
p/n: 20-1040-21
Plug, hole in dog leg cover. Installs at front of door where bolt to adjust vent window frame is located. This body plug covers a sheet metal hole that is one and one half (1-1/2) inch in diameter.
Body Hole Plug
p/n: 20-1039-21
Plug, cowl and floor pan. This body plug covers a sheet metal hole that is one and one fourth (1-1/4) inch in diameter.
Brake adjustment hole plug
p/n: 70-1092-24
Plug, brake adjustment hole. Fits five sixteenths (5/16) inch by one (1) inch slot. Most models with drum brakes.Length: 1.25 inches. Height: .875 inches.
