Please click on the part name in red in order to get a complete description.
Bumper, adjustable type, hood front. Cadmium plated bolt (5/16)-18 x 1-1/4", rubber bumper 1-1/8" in diameter, 5/8" thick.Height: 1.875 inches.
Grommet, instrument panel to windshield frame. Two (2) to six (6) required.Length: 1.3125 inches. Width: 1.0625 inches.
Bumper, hood to fender ledge. Self retaining type. See our # 50-0194-42 for center type.
Grommet, firewall wiring harness. For wiper control cable, heat tube, etc. Sheet Metal Hole: 1" Center Hole: 1/8" Secondary Holes: 1/16" Outside Diameter: 1-5/16" Slot Width: 1/16"
Pad, headlight dimmer switch. Rubber slip-over cover for floor mounted switch.
Spacers, spark plug wires in organizer bracket.
Grommet, main wiring loom through firewall.
Bumper, front hood adjuster. Our #70-0294-42 type cap attached to 5/16-18 threaded bolt. In 1957-1958 use four (4) per vehicle. In 1959-1960 use two (2) per vehicle.
Grommet, overdrive pull cable.
Grommet, shock absorber
Gasket, headlight bucket to fender.
Bumper, fuel filler door, rear fender. With steel core, screw retained two (2) per car.Width: .5 inches. Height: .625 inches.
Grommet, for wiring through firewall.Additional usage: Buick 1957-58: Water Temp Gauge wire 1964-67: Special & Skylarks (w/o AC) heater blower wire.
Bumper, glove box check link. Fits on glove box door arm as needed.Length: .75 inches. Width: .5625 inches. Height: .3125 inches.
Bushing, spring and shackle, rear.
Cushion (stem bumper), window stop, lower. For front and rear door, rear side and quarter windows as required.
Dust cover, tie rod ends.
This weatherstrip was designed from an original part for a specific application but has many uses outside of its original purpose. The seal is structured to be applied to the body of the car.
Pad, for each body bolt under frame bracket, to cushion washer and nut. Fully molded rubber. One and seven eighths inch (1 7/8") outside diameter by seven eighths inch (7/8") inside hole diameter by nine sixteenths inch (9/16) height.
Gasket, headlight bucket to fender. Cork.
Bumper, trunk opening on lid. Metal core, as original, screw held. Two (2) required per car.
Pad, lock assembly to deck lid.
Bumper, front door above the upper hinge on the upper radius of the door. Stiff-backed, retained by screw, mounted on door only.
Door edge weatherstrip made from high quality EPDM sponge rubber. Excellent for use on many different vehicle models.
Grommet, shift lever insulator. One (1) per car. Three eighths (3/8) inch inside diameter by five eighths (5/8) inch barrel by one half (1/2) inch long.