Please click on the part name in red in order to get a complete description.
This windshield gasket mounts around the full perimeter of the front glass and has the divider bar molded directly into it. It has properly molded corners to precisely conform to the glass and fit the windshield just like original.
This rear window gasket mounts around the full perimeter of the back glass and has properly molded corners for a precise, factory fit.
Weatherstrip, hood to radiator. Proper rubber cross section with pre-drilled holes, cut outs and included attaching clips.Length: 61.75 inches.
Filler, rear bumper to body filler.
Seal, fenderskirt edge. Two (2) strips of proper cross section forty two (42) inches long.Length: 42.0 inches. Width: .8125 inches.
This trunk weatherstrip is designed from the original part for superior fitment and seal. The seal mounts around the full perimeter of the trunk directly to the body.
Window felt inner and/or outer. One (1) pair of three (3) foot lengths. Flexible, pile lined, rubber covered, with black bead. For front door, rear door and quarter windows.
Cover, manual transmission brake or clutch pedal. Fully molded, scuff resistant rubber with exceptional attention to detail.
Window felt inner and/or outer. Single six (6) foot length. Flexible, pile lined, rubber covered, with black bead. For front door, rear door and quarter windows.
Weatherstrip, hood to cowl. Proper extrusion approximately sixty (60) inches long.Length: 60.0 inches. Width: .6875 inches.
Seal, wiper motor mounting. Attaches under the cowl on the firewall. This is for models with a three speed wiper motor.
Grommet, fuel filler neck. Replaces original factory #2203472.
Bumper, hood to fender ledge.
This Trunk Lid Bumper is quality reproduction of the original factory part. This rubber bumper attaches to the vehicle body to support / cushion the trunk lid closure.
Cover, battery clamp. Control unsightly sulfate buildup. Help protect the nearby metal and finish. Good copy from original part.Length: 3.5 inches.
Bumper, hood to fender side, at front.
Grommet, dimmer switch for carpet application.
Masticated sheet. Three thirty seconds (3/32) inch thick rubber sheet containing random milled cotton cord reinforcement for front end splash aprons, etc. This product is a four (4) foot wide roll, and will only be sold in four (4) square foot multiples
This Door to Body Bumper is quality reproduction of the original factory part. Use varies depending upon model and body type. Some models uses four (4) bumpers for front doors and four (4) for rear doors.
Liner, mohair. Liner with a rubber backing. Apply with adhesive to division bars and channels. Helps reline guide bars on lock side of hardtops and convertibles.
Mounting pad, continuous for lights, hinges, brackets, and other bright work when no molded pad is available.
This Hood to Fender Bumper is quality reproduction of the original factory part. This rubber bumper attaches to the front fender to support / cushion the hood closure. Usually requires up to ten (10) bumpers per vehicle.
This Hood Bumper is quality reproduction of the original factory part.