This kit includes the major weatherstrip components needed for the body of your restoration project.
Original equipment style side window horizontal seal kit (also known as beltline weatherstrip). Eight (8) piece kit includes inner and outer felt beltline weatherstrip for each door and quarter windows. These strips wipe the side windows when the glass is
This windshield gasket mounts around the full perimeter of the front glass and has properly molded corners for a precise, factory fit.
Convertible roof rail kit. Includes front bow.
Door edge weatherstrip with molded ends. This part is the primary door to body weatherstrip. Includes clips for easy installation. Made of top quality rubber. Note: order #70-2053-79 end cap fillers separately.
Convertible Hinge Pillar Weatherstrip - Attaches to the body and seals between the A-pillar post and the front section of the door or vent window frame when the door is closed.
Weatherstrip, door seal end cap or filler. Fully molded with metal core.
Door lock pillar seal. This part seals the bottom of the rear side window, and may also be known as a door jamb seal.
Weatherstrip, hood to radiator. Proper rubber cross section with pre-drilled holes, cut outs and included attaching clips.Length: 62.0 inches.
Grommet, gas tank filler tube. Fully molded rubber. Two and seven eighths inch (2 7/8") outside diameter by two inches (2") inside hole diameter by seven eights inch (7/8") height.
Seal, fenderskirt edge. Two (2) strips of proper cross section forty two (42) inches long.Length: 42.0 inches. Width: .8125 inches.
This trunk weatherstrip is designed from the original part for superior fitment and seal. The seal mounts around the full perimeter of the trunk directly to the body.
Cover, manual transmission brake or clutch pedal. Fully molded, scuff resistant rubber with exceptional attention to detail.
Weatherstrip, hood to cowl. Proper extrusion approximately sixty (60) inches long.Length: 60.0 inches. Width: .6875 inches.
Side window vertical leading edge weatherstrip.
Seal, wiper motor mounting. Attaches under the cowl on the firewall. This is for models with a three speed wiper motor.
Bumper, hood to fender ledge.
Cover, battery clamp. Control unsightly sulfate buildup. Help protect the nearby metal and finish. Good copy from original part.Length: 3.5 inches.
Bumper, hood to fender side, at front.
Masticated sheet. Three thirty seconds (3/32) inch thick rubber sheet containing random milled cotton cord reinforcement for front end splash aprons, etc. This product is a four (4) foot wide roll, and will only be sold in four (4) square foot multiples
Run channel liner helps reline guide bars on lock side of hardtops and convertibles. Available by the foot.
This Door to Body Bumper is quality reproduction of the original factory part. Use varies depending upon model and body type. Some models uses four (4) bumpers for front doors and four (4) for rear doors.
Mounting pad, continuous for lights, hinges, brackets, and other bright work when no molded pad is available. Available by the foot.