Please click on the part name in red in order to get a complete description.
Door edge weatherstrip. This part is the primary door to body weatherstrip. Contains plastic pins that are attached to the door weatherstrips and molded ends with metal cores.
Beltline weatherstripMade from Original style material. For vehicles with SPECIAL MOLDING. Side window horizontal seal (also known as beltline weatherstrip). These strips wipe the side windows when the glass is lowered. They come ready to install with finished ends and body curvature bends for a factory like appearance. This set includes the inner and outer seals for all side windows.
Hardtop roof rail weatherstrip. This part fits on the roof of the vehicle and seals the side window when the window is fully raised.
This rear window gasket mounts around the full perimeter of the back glass and has properly molded corners for a precise, factory fit.
Seals, upper front corner of door window.
Made from Original style material. For vehicles WITHOUT SPECIAL MOLDING. Side window horizontal seal (also known as beltline weatherstrip). These strips wipe the side windows when the glass is lowered. They come ready to install with finished ends and body curvature bends for a factory like a
Leaf Spring Shackle Bushing Kit - For rear of rear leaf spring. Complete with shackle bars and bolt assembly with rubber bushings. Two (2) kits required per car.
Seal, rear bumper to body.
Weatherstrip, outer beltline (sometimes called "scraper seal"). For use on front, rear, and quarter windows without a chrome reveal molding at the window beltline. Small stainless bead with rubber lip. Three (3) foot length.
Channel, flexible door window run. Stainless steel beaded. Sixty (60) inches long.
Window felt inner and/or outer. One (1) pair of three (3) foot lengths. Flexible, pile lined, rubber covered, with black bead. For front door, rear door and quarter windows.
Seal, top of radiator to hood.
Seal, steering column to floor.
Seal, radiator grille opening. Cut to fit.
Gaskets, taillight to body.
Channel, door window glass lower rubber. Front or rear doors. One (1) pair does two (2) windows.
Rear Leaf Spring Bushing - Original style leaf spring bushings used in front eyes of rear leaf springs. Requires two (2) spring bushings per vehicle.
Seal, clutch pedal rod.
Pad, brake pedal. Models with automatic transmission and manual brakes.
Insulator, gear shift.
Insulator, transmission gear shift column lever.
Rear Leaf Spring Insulator Pad - An exact replacement of the rear spring center mount rubber insulator block that mounts below the leaf spring. Four (4) required per vehicle. Fits 2-1/2" leaf spring.
Gaskets, air vent inlet duct to cowl.
Gaskets, taillight lens.
Repair kit, stabilizer bar end. Eleven (11) piece set. Two (2) kits required per car. Hex head bolt. 3/8"-16nc x 6-7/8" lg. Comes with metal sleeve, four (4) cup washers and four (4) rubber grommets.
Seal, accelerator pedal rod.
Insulator, front coil spring upper.
Hood Bumper, radiator support hood. Includes jamb nut. Vulcanized "Rounded Top" type. Two (2) required per car.
Plugs, quarter panel drain.
Gaskets, parking light lens.
Bumper, brake and clutch pedal arm.
Plug, brake adjustment hole. Fits five sixteenths (5/16) inch by one (1) inch slot. Most models with drum brakes.Length: 1.25 inches. Height: .875 inches.
Gasket, rear license plate lamp lens.
Tip, sun visor arm boot. Used where sun visor hooks to clip in center. Two (2) required per car.