Hardtop roof rail weatherstrip. This part fits on the roof of the vehicle and seals the side window when the window is fully raised.
Door edge weatherstrip. This part is the primary door to body weatherstrip.
Hinge Post Weatherstrip Seals for upper front corner of door window.
Front Coil Spring Saddle Insulator Kit - Two front coil spring bushings and two spring insulators to restore the performance of your classic vehicle. Requires two (2) per car.
This U Jamb Lock Pillar Filler pair seals the bottom of the rear side window and may also be known as a door jamb seal.
Window felt inner and/or outer. Flexible, pile lined, rubber covered, with black bead. Available in 3ft pairs.
This trunk weatherstrip is designed from the original part for superior fitment and seal. The seal mounts around the full perimeter of the trunk directly to the body.
Seal, steering column to floor.
Seal, hood to cowl. Includes fasteners imbedded in place as original.
Rear Leaf Spring Bushing - Original style leaf spring bushings used in front eyes of rear leaf springs. Requires two (2) spring bushings per vehicle.
Pad, brake pedal. Models with manual transmission and manual brakes.
Pad, brake pedal. Models with automatic transmission and manual brakes.
Insulator, gear shift.
Repair kit, stabilizer bar end. Eleven (11) piece set. Two (2) kits required per car. Hex head bolt. 3/8"-16nc x 6-7/8" lg. Comes with metal sleeve, four (4) cup washers and four (4) rubber grommets.
Valve, quarter panel drain.
Insulator, front coil spring upper.
Pad, radiator mounting insulator.
This Clutch Pedal Rod Boot is designed from the original part for superior fitment and seal. Accordion style boot seals the clutch rod to the floor.
This Radiator Support to Hood Bumper is a quality replacement for the original factory part. This adjustable bumper attaches to the radiator support to cushion / stop the hood closure. Usually requires two (2) front bumpers each per vehicle.
Plugs, quarter panel drain.
Bumper, brake and clutch pedal arm.
Plug, hole in dog leg cover. Installs at front of door where bolt to adjust vent window frame is located. This body plug covers a sheet metal hole that is one and one half (1-1/2) inch in diameter.
Plug, cowl and floor pan. This body plug covers a sheet metal hole that is one and one fourth (1-1/4) inch in diameter.
Plug, cowl and floor pan. Three fourths (3/4) inch.
Tip, sun visor arm boot. Used where sun visor hooks to clip in center. Two (2) required per car.
This Door Bumper is a quality reproduction of the original factory part. Upper / Lower push-in type. Four (4) required per car.