Hood Bumpers & Fittings
Side strip, hood hinge, pinless. Fifty three (53) inches of roll formed stainless steel, better than original brass, much stronger & more durable. A lifetime job. No plating required. Not drilled for rivets.
Seal, hood to fender. Mounts on fender at hinge area inside hood opening. Fits around hood hinge assembly to isolate engine compartment from car interior. Replaces factory #E3SZ-16071-B, E3SZ-16072-B.
Pivot, hood hinge top strap. Cold rolled steel as original. Furnished in a four and one half (4-1/2) foot strip long enough for all models.
Pad, rear hood corners, steel core as original.Length: 5.50 inches.
Pads, hood front corners, exact copy with metal core as original. Right and Left.Width: 2.50 inches.
Guard strip, hood to cowl. Steel core with molded integral hood rest.Length: 14.875 inches.
Pad, front hood corners, exact copy of original.Width: 2.75 inches.
Bumpers, hood to cowl. Steel core, one and one half (1-1/2) inch by four and one half (4-1/2) inch.Length: 4.50 inches. Width: 1.50 inches.
Protector, hood center. Steel core as original threaded to fit original screws.
Bumpers, hood top panel to side panels. Steel core as original. Four (4) per car. Four (4) piece set.Length: 2.0 inches. Width: 1.0 inches.
Pads, hood front corners. Large self prong type with metal core molded left and right.Length: 3.375 inches.
Pads, hood hold-down clamp, mount on clamp swivels to hold hood corners in. Set of four (4) rubber pads in solid brass, chrome plated cups.
Pads, hood rear corners, exact copy with metal core as original. Right and Left (reversible).Width: 2.50 inches. Height: 1.75 inches.
Pads, hood front corners, large type. Molded right and left with metal cores and double tab retainers.Length: 3.1875 inches. Width: 2.125 inches.
Pads, hood corners. right and left. Threaded steel core.
Pad, hood rear corner. Molded left and right with a metal core.Length: 2.50 inches. Width: 1.75 inches.
Pads, hood rear corners. Threaded metal core.
Pads, hood corner, right and left. Threaded steel core.
Bumper, hood panel assembly. Same as our #40-0164-42. (except vulcanized to steel cores).Length: 1.375 inches. Width: 1.3375 inches.
Wedge pads, hood side ventilators. Fourteen (14) piece set.