Search Results
Harmonic balancer service
p/n: 40-0372-12
Vibration Damper (crankshaft impulse neutralizer assembly). Revulcanization service only.
Transmission handbrake damper service
p/n: 40-0351-12
Plate assembly transmission damper, brake drum, parking or hand. Revulcanization service only.
Accelerator pedal pad
p/n: 40-0014-40
Accelerator pedal. Perfect copy in every detail, including heavy two (2) piece metal core with mounting tabs as original.Length: 10.3125 inches.
Windshield Weatherstrip Channel
p/n: 17-0032-52
12 (twelve) foot strip of windshield weatherstrip channel. Seals windshield glass to body and protects interior of vehicle.
Accelerator pedal pad
p/n: 40-0524-40
Accelerator pedal. Perfect copy in every detail, including heavy one (1) piece metal core with mounting tabs as original.Length: 10.375 inches.
Door check strap
p/n: 40-0535-70
Strap, door check. T-type, special heavy duty construction of rubber with multiple ply webbing and molded-in steel crossbar. Full length as original with one eighth (1/8) inch by seven eighths (7/8) inch steel crossbar.
Motor mount service
p/n: 40-0374-11
Front engine support (insulator). One per car. Revulcanization service only.
Side roof rail weatherstrip
p/n: 40-0095-65
Weatherstrip, convertible top to side windows. Fifteen sixteenths (15/16) inch by five eighths (5/8) inch. Sold in twelve (12) foot strips only.
Axle rebound pad
p/n: 40-0373-32
Bumpers, rear axle. Revulcanization service only.Length: 3.0 inches.
Front spring bumper
p/n: 40-0349-32
Bumper, front spring to frame. (Also known as front axle bumper).Length: 5.0 inches. Width: 2.5625 inches.
Side mount grommet
p/n: 40-0005-37
Grommets, sidemount support arm on fender. Two and one half (2-1/2) inch inside diameter by four and seven eighths (4-7/8) inch outside diameter.
Headlight mounting pad service
p/n: 40-0312-14
Anchor pad, head light crossbar to radiator shell. Right and left. Revulcanization service only.
Rear bumper grommet
p/n: 40-0112-30
Grommets, rear bumper symmetrical, right and left. Perfect detailing on both inner and outer surfaces. Fully molded rubber. Three and three fourths inch (3-3/4") outside length by two and one fourths inch (2-1/4") outside width by one and three fourths i
Swing-out Windshield Weatherstrip
p/n: 70-0057-52
This swing-out windshield weatherstrip comes in an twelve foot (12') strip and mounts into the metal channel attached to the glass. The rubber slides into the T-groove and creates a seal when the glass is pressed against the body of the vehicle.
Exhaust system hanger service
p/n: 40-0350-13
Muffler support hanger insulator assembly. Revulcanization service only.
Hood bumper
p/n: 40-0313-42
Bumper, hood panel assembly. Same as our #40-0164-42. (except vulcanized to brass cores).Length: 1.375 inches. Width: 1.3375 inches.
Shock absorber arm seal
p/n: 40-0081-32
Dust seal set, shock absorber link, rubber only. Eight (8) piece set.
Rumbleseat step pad
p/n: 40-0012-44
Pad, rumbleseat step bears Chrysler medallion logo in center.Height: .50 inches.
Brake and clutch pedal pad
p/n: 40-0072-22
Pad, brake and clutch pedal.Length: 3.9375 inches. Width: 2.9375 inches.
Fender welting 1/4" bead 50ft
p/n: 70-1098-44
Welting, fender. Superior quality, proper construction of reinforced black vinyl over vinyl core, one and three eighths (1-3/8) inch wide. One fourth (1/4) inch bead, fifty (50) foot roll. Typically used to attach four (4) fenders to body. For twenty five
Fender welting 3/16 bead 50ft
p/n: 70-1100-44
Welting, fender. Superior quality, proper construction of reinforced black vinyl over vinyl core, one and three eighths (1-3/8) inch wide, three sixteenths (3/16) inch, fifty (50) foot roll. Typically used to attach four (4) fenders to body. For twenty fi
Fender welting 50ft chrome
p/n: 70-1102-44
Welting, fender, bright chrome vinyl, three sixteenths (3/16) inch bead, one and one half (1-1/2) inch width. Superior quality. Fifty (50) foot roll. Typically used to attach four (4) fenders to body. For twenty five (25) foot roll see #70-1101-44.
Steering column grommet
p/n: 70-1512-36
Insulator, steering column bracket. Two (2) pieces of extruded rubber like original.Width: 1.3125 inches.
Carpet heel plate
p/n: 40-0087-88
Heel pad for carpet. Identical to original. Five and three fourths (5-3/4) inch by ten and one half (10-1/2) inch, to be stitched in place.Length: 10.
Hood corner pad
p/n: 40-0127-42
Pads, hood corners, brass core. Approximately 80 degree angle. Integral tabs for installing.Length: 1.50 inches.
Hood corner pad
p/n: 40-0128-42
Pads, hood corners. Square type, brass core. Integral installation tabs. 90 degree angle, used on front or rear corners, as required.
Window weatherstrip
p/n: 70-0084-77
Weatherstrip, fixed back and quarter windows, plain type. Seven and one half (7-1/2) foot strip.Length: 90.0 inches. Width: .5625 inches. Height: .
Windshield weatherstrip
p/n: 40-0320-52
Seal, windshield. Lower, glass frame to cowl. Approximately four (4) foot strip. Note: for 2 piece windshields
Fuel neck grommet
p/n: 40-0091-39
Grommet, fuel filler neck. Fully molded large oval style. Bottom is flat. Four and one half inch (4 1/2") outside width by five by one half inch (5 1/2") outside length. Two and five sixteenths inch (2-5/16") inside hole diameter by three fourths inch (3/
Body Anti-Squeak Rubber
p/n: 60-0054-73
Bulb type seal, gravel shield-to-rear bumper, anti-squeak. Also used as a door weatherstrip for some makes and models. Twelve (12) foot strip.
Cowl vent gasket
p/n: 40-0170-54
Gasket, cowl vent, high grade sponge for twin cowl vents of thirty four (34) inch circumference.Length: 34.0 inches. Width: .75 inches. Height: .
Hood bumper
p/n: 40-0164-42
Pad, hood panel center bracket. Hollow, to fit over original steel bracket.Length: 1.375 inches. Width: 1.375 inches.
Side mount cover pad
p/n: 40-0314-37
Anti-rattle, spare wheel cover in fenderwell.Width: .25 inches.
Vacuum clutch cylinder boot
p/n: 40-0084-24
Boot, automatic clutch vacuum cylinder rod.Length: 4.0 inches.
Fuel neck grommet
p/n: 40-0067-39
Grommet, fuel filler neck. Oblong, fully molded rubber. Four and one eighth inch (4-1/8") outside length by two and one fourth inch (2-1/4") inside diameter.
Hood bumper
p/n: 40-0354-42
Bumper, fender to hood. Two (2) per car. Held by four (4) rivets.Length: 2.9375 inches.
Door weatherstrip
p/n: 40-0208-73
Weatherstrip, door bottom on door. Three thirty seconds (3/32) inch thick, two (2) inch wide, perforated for retaining screws. Forty eight (48) inch strip.
Fender welting 1/4" bead 25ft
p/n: 70-1097-44
Welting, fender. Superior quality, proper construction of reinforced vinyl over vinyl core, one and three eighths (1-3/8) inch wide, black only. One fourth (1/4) inch bead, twenty five (25) foot roll. Typically used to attach two (2) fenders to body. For
Fender welting 25ft chrome
p/n: 70-1101-44
Welting, fender, bright chrome vinyl, three sixteenths (3/16) inch bead, one and one half (1-1/2) inch width. Superior quality. Twenty five (25) foot roll. Typically used to attach two (2) fenders to body. For fifty (50) foot roll see our #70-1102-44.
Fender welting 3/16 bead 25ft
p/n: 70-1099-44
Welting, fender. Superior quality, proper construction of reinforced black vinyl over vinyl core, one and three eighths (1-3/8) inch wide, three sixteenths (3/16) inch, twenty five (25) foot roll. Typially used for attaching two (2) fenders to body. For f
Brake and clutch shank seal
p/n: 40-0175-24
Seal, brake and clutch pedal shank to floorboard. One and one half (1-1/2) inch by two and one eighth (2-1/8) inch by three fourths (3/4) inch thick.
Horn trumpet grommet
p/n: 40-0086-21
Grommet for trumpet horn wire through motor cover. Close reproduction. Two (2) per car.
Flexible Run Channel
p/n: 40-0309-57
Channel, side window glass, vertical run. Flexible, felt lined, rubber covered channel. Available in 30" pair.
Brake and clutch shank seal
p/n: 50-0066-24
Grommet, brake and clutch pedal floor seal.Width: 1.8125 inches. Height: 2.375 inches.
Brake and clutch shank seal
p/n: 40-0016-24
Seal, brake and clutch pedal shank to floorboard (draft excluder).Length: 2.4375 inches. Width: 1.875 inches.
Taillight mounting pad
p/n: 40-0061-15
Pad, taillight mounting.Chrysler 1932-33 Pad, tail light mounting. Chrysler and other WPC cars. Chrysler 1932-33 Pad, rumbleseat step mounting.
Battery clamp cover
p/n: 70-0095-21
Cover, battery clamp. Control unsightly sulfate buildup. Help protect the nearby metal and finish. Good copy from original part.Length: 3.5 inches.