Search Results
Please click on the part name in red in order to get a complete description.
Horn trumpet grommet
p/n: 40-0086-21
Grommet for trumpet horn wire through motor cover. Close reproduction. Two (2) per car.
Fuel neck grommet
p/n: 60-0405-41
Grommet, fuel filler neck. Oblong, fully molded rubber. Three and eleven sixteenths inch (3 11/16") outside width by four and one fourth (4 1/4") outside length. Two and one fourth inch (2 1/4") inside hole diameter by one half inch (1/2") height.
Brake and clutch shank seal
p/n: 30-0055-24
Seals, brake and clutch pedal shanks, against underside of floorboard.Length: 2.5625 inches. Width: 1.75 inches.
Parking light mounting pad
p/n: 30-0447-17
Pad, parking light to fender. Requires two (2) per car.Length: 4.125 inches.
Radiator mounting pad
p/n: 30-0451-31
Spacer or Pad, lower radiator anchor stud. Used in conjunction with our #30-0395-31.Height: .3125 inches.
Headlight mounting pad
p/n: 40-0300-14
Mounting pad, headlight bracket to fender. This is a plain, flat, reversible un-beaded pad as original.Length: 6.4375 inches.
Flexible run channel
p/n: 40-0309-57
Channel, side window glass, vertical run. (Use our #40-0280-57 across top).
Fender welting
p/n: 20-1590-44
Fender welting. Thirty (30) foot roll. Black, textured finish. 1/4" bead.
Gearshift boot
p/n: 50-0035-24
Boot, gearshift. Black rubber. For brown see our #50-0035-89.Width: 2.8125 inches.
Engine Mount Kit
p/n: 20-1980-11
Kit, engine mount. Includes one (1) each of 34031-S, 78-6029-A, B-6038-C, B-6048. B-6039-A and B-6047.
Headlight mounting pad
p/n: 60-0163-14
Pad, headlight bracket mounting right and left. One and seven eighths (1-7/8) inch by two and seven eighths (2-7/8) inch overall.Length: 2.875 inches.
Bowdrill cloth tape
p/n: 70-1175-65
Tape, black bowdrill cloth. Adhesive backed, used to create cloth cover surface for side rail weatherstrips typically. Five (5) inches by five (5) foot roll. Pressure sensitive, for covering convertible side window weatherstrip such as our #70-1170-99 or
Brake and clutch shank seal
p/n: 50-0066-24
Grommet, brake and clutch pedal floor seal.Width: 1.8125 inches. Height: 2.375 inches.
Taillight mounting pad
p/n: 60-0075-15
Pad, taillight and license bracket mounting. Two and five eighths (2-5/8) inch by four and one half (4-1/2) inch.Length: 4.5 inches. Width: 2.625 inches.
Side mount grommet
p/n: 40-0140-37
Grommet, sidemount carrier brace to fender. One and five sixteenths (1-15/16) inch outside diameter by one half (1/2) inch inside diameter.
Taillight mounting pad
p/n: 40-0299-15
Mounting pad, taillight bracket to fender. This is a plain, flat un-beaded pad as original, and reversible. Four and three fourths (4-3/4) inch long.
Taillight gasket
p/n: 30-0523-15
Gasket, taillight door. Two (2) strips twelve (12) inches long.Length: 12.0 inches. Width: .25 inches.
Brake and clutch shank seal
p/n: 40-0016-24
Seal, brake and clutch pedal shank to floorboard (draft excluder).Length: 2.4375 inches. Width: 1.875 inches.
Brake and clutch pedal pad
p/n: 50-0054-22
Pad, brake and clutch pedal. Black rubber. For brown see our part #50-0054-89. Perfect copy, fine detail.Width: 3.125 inches. Height: 2.125 inches.
Cowl vent gasket
p/n: 60-0087-54
Gasket, cowl vent, lip type. Sponge rubber, for three and seven eighths (3-7/8) inch by fifteen (15) inch cowl vent.Length: 15.0 inches. Width: 3.
Front Door weatherstrip
p/n: 20-0390-72
Door edge weatherstrip. This part is the primary door to body weatherstrip. Includes enough to do front, top and backside of one door.
Starter button
p/n: 60-0322-21
Starter button, push on replacement to rod. Two (2) inch outside diameter.
Spring shackle bushing
p/n: 11-0014-32
Bushing, spring eye leaf and shackle bolt, 1-1/2" barrel diameter with 1/2" inside diameter hole. Replaces Harris #998.
Brake clutch or rumbleseat pad
p/n: 20-0325-22
Pad with pyramid design like original. Used a clutch and brake pedal pad for all models, and as a rumble-seat step pad for cars so equipped.
Horn trumpet grommet
p/n: 70-0302-21
Grommets, horn projector. For under hood horn brackets. Two (2) per car.
Taillight mounting pad
p/n: 60-0364-15
Pad, taillight mounting to rear fender.Length: 1.0625 inches.
Trunk Weatherstrip
p/n: 70-0798-84
This trunk weatherstrip is designed from the original part for superior fitment and seal. The seal mounts around the full perimeter of the trunk directly to the body.
Fabric Hood To Cowl Lacing
p/n: 20-0352-42
Fabric Hood To Cowl Lacing - Cloth measuring approximately 90 inches in length and complete with mounting screws.
Shock absorber arm bushing
p/n: 30-0192-32
Bushing, shock absorber arm. Restore proper shock action.Height: 1.375 inches.
Trunk or Rumbleseat Weatherstrip
p/n: 20-2129-84
This trunk weatherstrip is designed from the original part for superior fitment and seal. The seal mounts around the full perimeter of the trunk directly to the body.
Door bumper
p/n: 17-0041-70
Pad, door jamb, large size, retained by both dovetail retainer from back, and screw through center. Usually 2 per door.Length: 2.125 inches. Width: 1.
Wiper transmission gasket
p/n: 50-0081-53
Gasket, windshield wiper transmission.Width: 2.5625 inches. Height: .8125 inches.
Rear Spring Pad
p/n: 70-0191-32
Pad, rear spring insulator for two (2) inch wide springs. (see our number 70-0245-32 for two and one fourth (2-1/4) inch springs). Cloth reinforced. Four (4) per vehicle.
Rear Window Gasket Weatherstrip
p/n: 20-0394-81
This rear window gasket weatherstrip is made just like the original and mounts around the full perimeter of the back glass. The ends may require trimming and bonding for installation.
Taillight mounting pad
p/n: 40-0092-15
Pad, taillight mounting, plain type without bead. Compare with our #40-0299-15.Length: 4.3125 inches. Width: 2.25 inches.
Headlight mounting pad
p/n: 60-0557-14
Pad, headlight bracket to radiator shell. Round, with proper type weatherlip as original. Two (2) required per vehicle.
Door bumper
p/n: 17-0038-70
Wedge cushion, door dovetail. This is the rubber block which goes behind the dovetail receiving bumper or shoe.
Headlight grommet
p/n: 60-0154-14
Grommet, headlight and horn wire conduit through radiator shell. Two (2) holes for two (2) separate conduits.Height: .21875 inches.
Firewall grommet
p/n: 60-0010-45
Grommet, firewall, oblong four (4) hole style. Fits steel retainer for throttle and choke cables, oil and temperature lines.
Door alignment pad
p/n: 70-1821-71
Wedge pads, door aligning.Length: 1.125 inches. Width: .5 inches. Height: .875 inches.
Vacuum cylinder seal
p/n: 30-0203-24
Seals, actuating valve rod, brake and clutch vacuum cylinder.Width: .875 inches.
Starter button cover
p/n: 60-0166-21
Cover, starter pedal button. Rubber slip over type for old metal. Two (2) inch outside diameter. If car doesn't have old metal, see our #60-0322-21.
Brown steering column cushion
p/n: 60-0012-89
Grommet, steering column to cowl, for U-bolt clamp. Brown rubber. For black see our #60-0012-36.Color:brown Height: 1.25 inches.
Door bumper
p/n: 17-0039-71
Bumper, round door side. An auxiliary door side bumper on door jamb pad.
Wheel cover cushion
p/n: 70-1024-38
Cushion, wheel disk. A fully molded alternative to our #70-0094-38.
Rear Spring Pad
p/n: 27-0010-35
Pad, rear spring insulator for one and three fourths (1-3/4") inch wide springs. Four (4) per vehicle.
Steering column cushion
p/n: 60-0012-36
Grommet, steering column to cowl, for U-bolt clamp. Black rubber. For brown see our #60-0012-89.Height: 1.25 inches.
Battery clamp cover
p/n: 70-0095-21
Cover, battery clamp. Control unsightly sulfate buildup. Help protect the nearby metal and finish. Good copy from original part.Length: 3.5 inches.
Door bumper
p/n: 30-0052-71
Bumper, door side, upper. Oblong type, perfect copy of original.Length: 2.4375 inches.
Door bumper
p/n: 17-0040-71
Bumper, oblong, door side. An auxiliary door jamb or side bumper.Width: 1.75 inches. Height: .75 inches.
Brake shaft stop bumper
p/n: 40-0343-24
Cushion cap assembly, brake and clutch pedal stop screw. Brass cap with vulcanized rubber pad.Height: .50 inches.
Spring or stabilizer bushing
p/n: 11-0020-35
Bushing, spring bracket on frame (Auburn and Cord 810 & 812). Also used as a grommet, front stabilizer bar (Graham models 116 & 120). Fully molded rubber. One and five eighths inch (1 5/8") outside diameter by three fourths inch (3/4") inside hole diamete
Channel filler weatherstrip
p/n: 20-2091-62
Seal, door glass to body. Fits in metal channel that holds glass. Also functions as the door to window seal when window is rolled up. Sold in a 36 inch strip.
Door bumper
p/n: 30-0002-71
Bumper, door side. One and one fourth (1-1/4) inch by two (2) inch.Length: 2.0 inches. Width: 1.25 inches.
Motor mount pad
p/n: 11-0028-11
Mounting pad, engine. One half (1/2) inch hole, one and five eighths (1-5/8) inch outside diameter. Original pattern, superior workmanship.
Coil wire sleeve
p/n: 40-0336-21
Nipple, sparkplug wire at sparkplug, for right angle plug terminal. This is an exact copy of the style used at the time. Not a modernistic makeover.
Bowdrill cloth tape
p/n: 70-1172-65
Tape, black bowdrill cloth. Adhesive backed, used to create cloth cover surface for side rail weatherstrips typically. Two and one half (2-1/2) inches by five (5) foot roll. Pressure sensitive, for covering convertible side window weatherstrip such as our
Door handle ferrule
p/n: 70-0111-69
Ferrule, for three fourths (3/4) inch outside door handle. Chrome plated brass. (See #70-0009-69 for grommet). Used for outside door handle or outside trunk handle.
Vent Window Division Bar Weatherstrip
p/n: 70-0040-56
Vent window division post seal. Extruded thirty (30") inch rubber strip that may have to be glued to your old original division post seal core, or directly to the division post.
Door bumper
p/n: 60-0581-71
Pad, door jamb. (Door side bumper). Two screw type with metal reinforcing inserts.
Spark plug retaining ring
p/n: 30-0352-21
Retaining ring, spark plug wire. Two (2) per car.Chevrolet 1935-48 Retaining ring, spark plug wire. Two (2) per car. All models.