Please click on the part name in red in order to get a complete description.
This kit includes the major weatherstrip components and some other essential parts needed for the body of your restoration project.
Front motor mount. Revulcanization service only. Send in cores and allow three weeks for service.
Rear door vent window seals. Authentic configuguration, fully molded with integral metal cores. Note: Order our #60-0682-56 division post seal strip separately.
This windshield gasket mounts around the full perimeter of the front glass and has properly molded corners for a precise, factory fit.
Hardtop roof rail weatherstrip. This part fits on the roof of the vehicle and seals the side window when the window is fully raised. Includes four (4) pins.
Rear door edge weatherstrip. Clip on type. This part is the primary door to body weatherstrip. Contains six (6) clips.
This front door vent window weatherstrip kit is a four (4) piece set that contains the main vent window seals and division post seals. All of the pieces were designed from original parts for a precise, factory fit.
This rear window gasket is designed from the original part for superior fitment and seal. The seal mounts around the full perimeter of the back glass and has vulcanized, or bonded, ends which means no cutting or splicing is required for installation.
Support, prop shaft center bearing. Revulcanization service only.
These front door vent window weatherstrips are the main seals needed to replace the rubber on your vent windows. They are designed and molded from original parts for superior fitment and seal.
Insulator, (cushion) motor support, rear at transmission. Revulcanization service only.
Door edge weatherstrip with molded ends. This part is the primary door to body weatherstrip. Includes six (6) clips for easy installation. Made of top quality rubber.
Front engine motor mounts, rubber insulating type pair. Aftermarket replacement. Length: 4.25 inches.
Bumper, motor yaw control. Two (2) per car on 2nd cross member. Revulcanization service only.Length: 3.0 inches.
Filler, splash apron. Die cut masticated rubber to authentic original dimensions. Includes all factory style holes required for installation.
Seal, fenderskirt edge, exact copy, trim notch for skirt lock at installation. Compare sketch with your original to be sure. Two (2), five (5) foot strips.
Weatherstrip, hood to cowl. Uses our part #70-1250-42, #70-1251-42 & 70-1252-42 (sold separately) to adjust hood.
Filler, headlight kit. Die cut masticated rubber to authentic original dimensions. Includes all factory holes required for installation.
Weatherstrip, inner beltline. Thick pile lined, without chrome bead. Nine sixteenths (9/16) inch high by nine thirty seconds (9/32) inch thick, two four (4) foot lengths.
Pad, front coil spring insulator cushion. Fully molded, mounts at top of front coil springs.