Please click on the part name in red in order to get a complete description.
This front door vent window weatherstrip kit is a four (4) piece set that contains the main vent window seals and division post seals. All of the pieces were designed from original parts for a precise, factory fit.
This windshield gasket mounts around the full perimeter of the front glass and has properly molded corners for a precise, factory fit.
These front door vent window weatherstrips are the main seals needed to replace the rubber on your vent windows. They are designed and molded from original parts for superior fitment and seal.
Door edge weatherstrip. This part is the primary door to body weatherstrip. Contains plastic pins that are attached to the door weatherstrips and molded ends with metal cores.
Side window horizontal seal (also known as beltline weatherstrip). These strips wipe the side windows when the glass is lowered. They come ready to install with finished ends and body curvature bends for a factory like a
Hardtop roof rail weatherstrip. This part fits on the roof of the vehicle and seals the side window when the window is fully raised.
This rear window gasket mounts around the full perimeter of the back glass and has properly molded corners for a precise, factory fit.
Seal, vent window upper tip at door window post.
Seal, deck lid dust. Lt. Gray. This part clips on the body across the back of the car where the trunk of the deck lid hinges.
Seal, deck lid dust. Black. This part clips on the body across the back of the car where the trunk of the deck lid hinges.
Front vent window division post seal. Fully molded with metal core and attaching tabs.
Side window vertical leading edge weatherstrip.
This trunk weatherstrip is designed from the original part for superior fitment and seal. The seal mounts around the full perimeter of the trunk directly to the body.
Seal, fender skirt rubber.
Pads, outside door handle. Four (4) piece set.
Kit, cowl lacing.
Gaskets, taillight lens to housing.
Bumpers, hood side bumper on fender. Push in type. Four (4) piece set.
Pad, parking brake pedal. Slip over type.
Seal, accelerator pedal linkage to firewall.
Gaskets, back-up light lens to body.
Gaskets, back-up light lens to housing. Before Serial # Y60,001
Gaskets, parking light lens.
Tip, folding top rear rail bending.
Bushing, folding top rear side rail to power cylinder.
Grommet, antenna lead-in. For front mount type.
Anti-rattler, trunk torsion bar.
Plug, cowl and floor pan. This body plug covers a sheet metal hole that is one and one seven eighths (1-7/8) inch in diameter.
Filler strip, window glass sash channel. One sixteenths (1/16) inch thick by 1-1/2 inches wide. For all applications fitting glass to sash channel not requiring weatherstrip type of filler. This is the highest quality linen back, rubber cork composition on
Bumper, brake and clutch pedal arm.
Bushing, door hinge.
Stop, glovebox arm.Ford Truck 1957-64 Stop, glovebox arm. Requires 2 each. Ford Cars 1955-68 Bumper, glovebox door check arm stop.
Plug, cowl and floor pan. This body plug covers a sheet metal hole that is one and one fourth (1-1/4) inch in diameter.
Plug, hole in dog leg cover. Installs at front of door where bolt to adjust vent window frame is located. This body plug covers a sheet metal hole that is one and one half (1-1/2) inch in diameter.
Plug, cowl and floor pan. Three fourths (3/4) inch.
Bumper, rear of door at belt line.
Gasket, rear license plate lamp lens.
Tip, sun visor arm boot. Used where sun visor hooks to clip in center. Two (2) required per car.
Standard Bumper - Commonly used for fuel filler or glovebox doors.