Please click on the part name in red in order to get a complete description.
Door edge weatherstrip, rear doors. This part is the primary door to body weatherstrip.
Door edge weatherstrip, front doors. This part is the primary door to body weatherstrip.
Channel, division bar glass run.
Seal, rear bumper to body.
Bumper kit, hood. Includes 1 set of C7AZ-16758-A, 1 set of C5AZ-16758-A and 1 set of C5ZZ-16763-B.
Bumper, front suspension lower arm.
Seals, front fender apron to frame lower rear.
Seals, cowl side panel to fender. Includes fasteners.
Kit, cowl lacing.
Mount, rear engine support on transmission.
Dust shield, A-arm.
Valves, rear floor pan extension drain.
Ends, rear stone deflector rubber. One (1) pair per car.
Seal, bottom of radiator support to frame air deflector. Twenty and one fourth (20-1/4) inch by twenty nine and three fourths (29-3/4) inch.
Seal, radiator support to bottom of radiator. "L" shaped. Twenty six and three eighths (26-3/8) inches long.
Seal, top of radiator support to hood air deflector.
Pad, radiator mounting. Lower.
Pad, parking brake pedal.
Bumper for front suspension upper arm. Measures three eighths (3/8) inch by sixteen (16) by eleven sixteenths with (11/16) inch bolt thread.
Seal, front fender extension to fender.
Pad, radiator mounting insulator.
Gaskets, parking light lens.
Bumper, hood on fender. Push-in type three fourths (3/4) inch wide. Four (4) piece set.
Bumper, hood on rear of fender. Rubber button tip only. Two (2) piece set.
Seals, headlight opening cover plate. With headlight covers.
Seal, radiator side air deflector. Three (3) inch by fourteen and one eighth (14-1/8) inch.
Insulator, front coil spring.
Hood Bumper, radiator support hood. Includes jamb nut. Vulcanized "Rounded Top" type. Two (2) required per car.
Bumper, ash tray door.
Plug, cowl and floor pan. This body plug covers a sheet metal hole that is one and one seven eighths (1-7/8) inch in diameter.
Pad, trunk lock cylinder sleeve. Four (4) lug cylinder type.
Bumper, door. Installs on back edge of door. Please check your car for quantities required.Usually two (2) to eight (8) per vehicle.
Stop, glovebox arm.Ford Truck 1957-64 Stop, glovebox arm. Requires 2 each. Ford Cars 1955-68 Bumper, glovebox door check arm stop.
Plug, cowl and floor pan. This body plug covers a sheet metal hole that is one and one fourth (1-1/4) inch in diameter.
Plug, hole in dog leg cover. Installs at front of door where bolt to adjust vent window frame is located. This body plug covers a sheet metal hole that is one and one half (1-1/2) inch in diameter.
Plug, cowl and floor pan. Three fourths (3/4) inch.
Standard Bumper - Commonly used for fuel filler or glovebox doors.