Hardtop roof rail weatherstrip. This part fits on the roof of the vehicle and seals the side window when the window is fully raised. Four (4) pieces.
Seals, front fender apron shield to control arm.
Seal, rear stone deflector.
Bumper kit, hood. Includes 1 set of C7AZ-16758-A, 1 set of C9AZ-16758-A and 1 set of C5ZZ-16763-B.
Bumper, front suspension lower arm.
Weatherstrip, hood- to-cowl seal. Includes fifteen (15) clips.
This trunk weatherstrip is designed from the original part for superior fitment and seal. The seal mounts around the full perimeter of the trunk directly to the body.
Mount, rear engine support on transmission.
Seal, top of radiator support to hood air deflector.
Seal, bottom of radiator support to frame air deflector.
Pad, parking brake pedal.
Gaskets, taillight lens to housing.
Gaskets, taillight housing to body.
Bumper for front suspension upper arm. Measures three eighths (3/8) inch by sixteen (16) by eleven sixteenths with (11/16) inch bolt thread.
Valve, quarter panel drain.
Seal, top of radiator support to radiator seal. Twenty three and thirteen sixteenths (23-13/16) inches long.
Gasket, taillight lens to housing. Center lamp body styles.
Gaskets, back-up light lens.
Pad, radiator mounting insulator.
Gaskets, parking light lens.
Bumper, hood on fender. Push-in type three fourths (3/4) inch wide. Four (4) piece set.
Bumper, hood on rear of fender. Rubber button tip only. Two (2) piece set.
Insulator, front coil spring.
This Radiator Support to Hood Bumper is a quality replacement for the original factory part. This adjustable bumper attaches to the radiator support to cushion / stop the hood closure. Usually requires two (2) front bumpers each per vehicle.
Bumper, door. Installs on back edge of door. Please check your car for quantities required.Usually two (2) to eight (8) per vehicle.
Plug, cowl and floor pan. This body plug covers a sheet metal hole that is one and one fourth (1-1/4) inch in diameter.
Plug, hole in dog leg cover. Installs at front of door where bolt to adjust vent window frame is located. This body plug covers a sheet metal hole that is one and one half (1-1/2) inch in diameter.
Plug, cowl and floor pan. Three fourths (3/4) inch.
This Door Bumper is a quality reproduction of the original factory part. Upper / Lower push-in type. Four (4) required per car.