Windshield Gasket
p/n: 70-2457-50
This windshield gasket is designed from the original part for superior fitment and seal. The seal mounts around the full perimeter of the front glass and has vulcanized, or bonded, ends which means no cutting or splicing is required for installation.
Windshield Gasket for V-Butted Glass - No Center Bar
p/n: 70-4812-52
This Windshield Gasket extrusion mounts around the full perimeter of the front glass. Used when removing center division bar and installing one (1) piece "V" Butted Glass. An extrusion only - NOT Spliced.
Swing-Out Windshield Weatherstrip
p/n: 40-0033-52
This Swing-Out Windshield Weatherstrip comes in an eleven (11') foot strip. The seal slides into the track (channel) attached to the glass that goes all the way around the windshield and creates a seal when the glass is pressed against the body of the vehicle.
Windshield Molding
p/n: 70-4806-52
This three-sided, one-piece Windshield Reveal Molding with no corner welds. The black with rain channel molding is designed from the original part for superior fitment.
Windshield Weatherstrip
p/n: 70-0997-52
This Window Weatherstrip is made of a high-quality EPDM dense rubber extrusion. The weatherstrip is used for the upper scraper seal.
Windshield Frame To Cowl Weatherstrip
p/n: 50-0105-52
This Windshield Frame To Cowl Weatherstrip fits into receiver in windshield lower frame, to butt against windshield stanchions or pads. This windshield-to-cowl weatherstrip is approximately four (4) feet in length.
3/32" Windshield Weatherstrip
p/n: 60-0055-52
This Windshield Weatherstrip is specially marked for trimming to accommodate both widths required (1" or 1-1/2"), sold as one and one half (1-1/2) inch width only. Available by the foot.