This reproduction Front or Rear Bumper Grommet pair is designed from the original part for an authentic fit, finish and appearance. Sold as a pair for both right and left.

Used as front or rear bumper for the 1935 Chrysler models on the list below. Used as rear bumpers for 1936-1937 vehicles on the list below. Fully molded rubber.

Fitment Note

• 1935: Chrysler CZ, C6 (front and rear) Plymouth some as required
• 1936: Chrysler C7, C8 Coupes (rear); Dodge D2 (rear); Plymouth P1, P2 (rear)
• 1937: Plymouth P3, P4 (rear) Possibly others

• Fully molded with top quality EPDM rubber to ensure durability
• Designed from original part so it fits correctly.
• Replaces factory #633941 and #633942.

 

Dimensions:
Four and one fourths inch (4-1/4") outside length
Three inches (3") outside width
One and five eighths inch (1-5/8") inside hole length
One half inch (1/2") inside hole width
One and fifteen sixteenths inch (1-15/16") height.

 

Product Note

Note: Compare to 40-0048-30 sold separately, which is similar but with some size difference.

---

Hand Crafted. Guaranteed to Fit. Made in USA.

 

Please check the Matching Vehicles tab to confirm this part is applicable to your vehicle.

 

*All parts sold by Steele Rubber Products are backed by our 100% Satisfaction Guarantee! Learn more!

---

Visit our Adhesive & Tools section for the adhesives, cleaners, sealers, tools and installation kits you may need for your repair or restoration project.