This hardtop roof rail weatherstrip is designed from the original part for superior fitment and seal. This part fits on the roof of the vehicle and seals the side window when the window is fully raised.
This front door weatherstrip pair is designed from the original parts for superior fitment and seal. These door seals mount directly to the body to seal against the full perimeter of both the front left and front right doors. This part is the primary door to body weatherstrip.
This rear window gasket mounts around the full perimeter of the back glass and has properly molded corners for a precise, factory fit.
Made from Original style material. Side window horizontal seal (also known as beltline weatherstrip). These strips wipe the side windows when the glass is lowered.
Hinge Post Weatherstrip Seals for upper front corner of door window.
Leaf Spring Shackle Bushing Kit - For rear of rear leaf spring. Complete with shackle bars and bolt assembly with rubber bushings. Two (2) kits required per car.
Seal, steering column to floor.
Channel, door window glass lower rubber. Front or rear doors. One (1) pair does two (2) windows.
Rear Leaf Spring Bushing - Original style leaf spring bushings used in front eyes of rear leaf springs. Requires two (2) spring bushings per vehicle.
Pad, brake pedal. Models with automatic transmission and manual brakes.
Insulator, transmission gear shift column lever.
Insulator, gear shift.
Rear Leaf Spring Insulator Pad - An exact replacement of the rear spring center mount rubber insulator block that mounts below the leaf spring. Four (4) required per vehicle. Fits 2-1/2" leaf spring.
Repair kit, stabilizer bar end. Eleven (11) piece set. Two (2) kits required per car. Hex head bolt. 3/8"-16nc x 6-7/8" lg. Comes with metal sleeve, four (4) cup washers and four (4) rubber grommets.
Insulator, front coil spring upper.
This Clutch Pedal Rod Boot is designed from the original part for superior fitment and seal. Accordion style boot seals the clutch rod to the floor.
This Radiator Support to Hood Bumper is a quality replacement for the original factory part. This adjustable bumper attaches to the radiator support to cushion / stop the hood closure. Usually requires two (2) front bumpers each per vehicle.
Plugs, quarter panel drain.
Bumper, brake and clutch pedal arm.
Plug, brake adjustment hole. Fits five sixteenths (5/16) inch by one (1) inch slot. Most models with drum brakes.Length: 1.25 inches. Height: .875 inches.
Gasket, rear license plate lamp lens.
Tip, sun visor arm boot. Used where sun visor hooks to clip in center. Two (2) required per car.