Please click on the part name in red in order to get a complete description.
This kit includes the major weatherstrip components and some other essential parts needed for the body of your restoration project.
This front door vent window weatherstrip kit is a four (4) piece set that contains the main vent window seals and division post seals. All of the pieces were designed from original parts for a precise, factory fit.
Front motor mount. Revulcanization service only. Send in cores and allow three weeks for service.
Hardtop roof rail weatherstrip (6 window). This part fits on the roof of the vehicle and seals the side window when the window is fully raised. Note: this is for 6 window 4dr hardtops only (vehicles with rear quarter windows). See part #70-
These front door vent window weatherstrips are the main seals needed to replace the rubber on your vent windows. They are designed and molded from original parts for superior fitment and seal.
Weatherstrip, fixed quarter window.Width: 20.5 inches. Height: 10.25 inches.
This rear window gasket mounts around the full perimeter of the back glass and has properly molded corners for a precise, factory fit.
This rear door weatherstrip is designed from the original part for superior fitment and seal. This seal mounts around the front, bottom, and rear of the door using pre-installed clips.
Door edge weatherstrip with molded ends. This part is the primary door to body weatherstrip. Includes 6 clips for easy installation. Made of top quality rubber. Note: this part may require a hole at the hinge at hinge pillar end for 1959
Bearing support bracket assembly, drive shaft center bearing. Revulcanization service only. .
This windshield gasket mounts around the full perimeter of the front glass and has properly molded corners for a precise, factory fit.
Cushion, motor support, rear on transmission to cross member. Revulcanization service only.
Weatherstrip, upper vertical on rear body lock pillar, eleven (11) inches long brass core, cloth facing. Right and Left.Length: 11.0 inches.
Gasket, defroster vent at base of windshield. One (1) pair required per car.Length: 14.5 inches. Height: .5625 inches.
Filler, hood to cowl side extension weatherstrip. Fully molded from soft rubber with all original details.
Filler, splash apron. Die cut masticated rubber to authentic original dimensions. Includes all factory style holes required for installation.
Front engine motor mounts, rubber insulating type pair. Aftermarket replacement. Length: 4.25 inches.
Run channel, front door window, for full length of division bar (approximately twenty nine (29) inches). Rigid, bright beaded edge, mohair lined channel, die trimmed and formed at top.
Seal, upper A-arm, inner and outer. Four (4) piece set.Height: 1.0 inches.
Bumper, front suspension, lower on A-arm. Fully molded with integral mounting bolt.Width: 2.125 inches.